Menu

Denver, CO · Sub-Zero

Ice Maker Repair

Clear-ice modules, inlet valves and drain lines on Sub-Zero ice makers.

$89 service call covers the trip and the full diagnosis, and comes off the total if you approve the repair.

Ice maker module lifted out onto a counter, mould and bin still full of cubes, meter and bagged parts alongside

How it usually gets described

  • No harvest at all, or a mould that stays full
  • Cloudy, hollow or fused cubes
  • Scale from hard Denver water choking production
  • Water pooling under the bin and refreezing

What gets checked

  1. Fill cup, mould and ejector inspected for scale — the usual Denver-water finding
  2. Inlet valve, fill volume and line pressure measured, and the filter age established
  3. Harvest cycle watched end to end instead of assumed, including the bin sensor
  4. Drain and bin base checked for the leak that refreezes into a ridge under the drawer

What it costs

The six bands a quote comes out of

Parts, and the labour to fit them, grouped the way faults actually turn up on a built-in. Yours lands inside one of these before anyone reaches for a screwdriver.

Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.

You get one firm number from inside the band, agreed with you before anything is opened up — and the service call comes off it the moment you say go ahead.

Door gasket or seal replacement
$270–$680
Evaporator or condenser fan motor
$320–$700
Defrost heater, thermostat or sensor
$280–$610
Ice maker, water valve or supply line
$260–$750
Electronic control board
$390–$1,000
Compressor or sealed-system repair
$1,490–$3,180

Ranges rather than starting prices: what moves inside a band is the part itself and how far the cabinet has to come out to reach it. For scale, a comparable built-in replacement, before installation and cabinetry work, runs $11,900–$23,680 — the comparison worth making before you decide either way.

Reviews

What owners say once the van has gone

Built-in calls in Golden Triangle, Five Points, Virginia Village and Belcaro.

4.9/ 51,739 reviews

  • Our bin was filling with cubes fused into one lump every couple of days. He diagnosed a lazy harvest cycle and a bin sensor covered in film. Both handled, though he came at the very end of the window.

    Roswell E.Five Points

  • Cubes came out hollow and tasted like the back of the freezer. He replaced the inlet valve, then swapped a filter that had clearly never been changed since the loft conversion. Ice is clean and clear now.

    Quillan H.Five Points

  • Cubes turned small and cloudy days before we had thirty people over, and I assumed the module was finished. It came down to low water pressure at the unit and a partly plugged screen. Cleaned, fill adjusted, full cycle watched.

    Ulysses G.Belcaro

Two ways in, and nothing to fill in

Give us the model number and what the cabinet is holding. That is usually enough to know which circuit is at fault before anyone is dispatched — and which parts belong on the van.